Geovision GV-R1352 Instalační příručka

GV-RK1352 and GV-R1352 Card Reader The GV-RK1352 and GV-R1352 are card readers designed to recognize identifications cards. GV-RK1352 comes with keyp

2. Select the COM port that is connected to the reader and click Open COM. The serianumber and firmware version of the reader will be automatically

4.2 Adding the Reader to GV-System 1. In GV-System, click the Configure button, select Accessories, and select GV Wiegand Capture Device Setting. T

5. Changing the Default Settings of Beeper and LED You can change the default settings of the LED and the beeper by enabling a GV-AS210 / d LED, g

2. Click Open COM. The serial number and the firmware version of the reader will be automatically detected. 3. To enable external control o

5.2 Wiring the Beeper and LED to the GV-AS Controller To wire the beeper and LED to GV-AS210 / 2110 / 400 / 410 / 4110 / 810 / 8110, connect the co

After wiring, you also need to go to GV-ASManager to select the alarm conditions that will set the device list, off the reader’s beeper. In GV-ASMan

5.3 Configuring the Beeper and LED Settings for Each Door/Gate After connecting the wires for beeper or LED, specify the conditions to trigger the

6. Setting UID or GID on GV-R/RK/DFR Config AP By default, the readers read the UID (unique identifier) on ID cards or key fobs. Using GV-R/RK/DFR C

To use GID, make sure there are two numbers on your GV-AS ID Cards / Key Fobs as shown below. If there is only one number on your GV-AS ID Cards /

7. Firmware Upgrade included in the Software CD. Important Notes before You Start Before you start updating the firmware, please read these impo

1. Physical Descriptions 1.1 Electric Wire GV-RK1352 Wire Color Function Red DC 7.5 ~ 12 V Black GND Yellow Beeper Orange Green LED Light Red

8. Specifications GV-RK1352 GV-R1352 CPU 8-bit microprocessor Frequency 13.56 MMifare CHz for ISO14443A (Mifare DESFire, Mifare Plus and lass)

February 6, 2015 21RK1352 Only) O tional accessories can exp bilities and versatilit V-RK1352 Card Reader. Consult your sales r information. 9. Ac

1.2 Keypad (GV-RK1352 Only) When accessing an entry using GV-RK1352, you can enter the door’s PIN code on the keypad or present the card and then en

2. Connecting the Reader to GV-AS Controller You can connect the readers to GV-AS Controllers through Wiegand or RS-485 interface. Note that the co

2.2 Connecting through RS-485 Interface The following diagrams use GV-RK1352 and GV-AS810 Controller as an example. Up to eight readers can be conne

2.2.1 Defining Readers on GV-AS Controller Web Interface Since multiple readers can connect to GV-AS Controller using one RS-485 interface, you nee

4. Next to Read Mode, select Read UID or Read GID to set the connected readers to read UID (unique identifier) or GID (GeoVision ID) on GV-AS ID Card

3. Installing the GV-R/RK/DFR Config AP Th master / slave status, and whether it reads UID or GID. When using the Config AP, the reader needs to b

4. Overlaying Card Numbers on GV-System Live View You can overlay card numbers recognized at the reader onto a camera channel on GV-System. To overl